AUtec Modular Serie Manual De Usuario página 32

LIMKDPU0
The display is divided into two lines:
- the upper line can show messages (if present, the message contents, operation and
meaning are decided by the machine producer),
- the lower line shows the values of the measurements that are carried out on the
machine.
In order to ensure that the DATAFEEDBACK operates correctly when the radio remote
control is started, make sure that numbers and/or letters (or dashes) appear on the lower
line of the display.
It is possible to verify the presence of interferences and disturbances in the radio link
between the DATAFEEDBACK TRANSMITTER and the MK10 DF transceiving unit.
Start the transceiving unit, keeping the actuator activated in order to power the
display light. The greater the number of displayed bars the better the
connection. Once this test has been carried out, switch the transceiving unit off
and on again.
The DISPLAY pushbutton (or selector) illuminates the
display to improve visibility in closed areas.
If present the SCROLL pushbutton (or selector) modifies
what is shown on the display according to the setting of
the machine producer.
TYPE OF
INDICATION
alphanumeric
characters
"NO DATA"
on the lower line
"- - - - - -"
on the lower line
" "
nella riga inferiore
INFORMATION SIGNALLING LEDs
The LEDs illuminate to indicate particular
machine conditions to the user (load limits,
operation conditions. . .)
!
REMEMBER that any signalling or data, as displayed by LED or LCD, can
never be considered or used as a safety signalling.
DISPLAY OR LED OPERATION
DISPLAY
DISPLAY ILLUMINATION AND SCROLL
DISPLAY INDICATIONS
INDICATION
MEANING
NORMAL
OPERATION
Data is not being received
from the machine
Data is not being received
because there is no radio link
Less than 3 bars indicates an
uncertain radio link
7
INTERVENTION
See "Diagnostic" in the DATAFEEDBACK
TRANSMITTER unit manual
Modify the frequency (see paragraph 9
"Programming")
///
Page 12