Connecting Cables - Eizo FlexScan S1701 Manual Del Usuario

Prior to use

Connecting Cables

Attention
• When replacing the current monitor with an monitor, be sure to change the PC settings for resolution and
vertical frequency to those which are available for the monitor referring to the resolution table
(Specifi cations Sheet on the CD-ROM) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User' s Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
CD player, etc
Connectors on
the PC
Audio output
connector
DVI-D connector
D-sub mini 15-pin
connector
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Compatible Resolutions/Frequencies
Use the monitor with the recommended resolution shown below.
Signal Resolution
Analog 1280 × 1024
Digital 1280 × 1024
* 1 Speaker applied model
4
Installation Setting/Adjustment
Stereo mini jack cable (supplied)*
Signal cable FD-C39 (supplied)
Digital connection
Signal cable MD-C87 (supplied)
Analog connection
Frequency
~ 75 Hz
60 Hz
Troubleshooting
Connectors on
the monitor
Audio input
1
connector*
DVI-D connector
D-sub mini 15-pin
connector
Dot Clock Remarks
135 MHz (Max.)
108 MHz (Max.)
1
VESA
VESA