Connecting To Power Supply; Switching On - Stihl RE 362 Manual De Instrucciones

Ocultar thumbs Ver también para RE 362:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 101

Connecting to Power Supply

The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA for 30 ms.
The power connection must correspond
to IEC 60364 - 1 and relevant national
regulations.
When the machine is switched on,
voltage fluctuations that occur under
unfavorable mains conditions (high
power line impedance) may negatively
affect other connected electrical
appliances. Trouble is not anticipated at
power line impedances less than
0.15 Ω.
The extension cord must have the
following minimum cross-section
depending on the mains voltage and
cord length.
RE 362, RE 362 PLUS, RE 462, RE 462 PLUS
Cord length
Minimum cross-
section
400 V / 3~:
up to 20 m
1.5 mm
20 m to 50 m
2.5 mm
230 V 3~:
up to 20 m
2.5 mm
2
20 m to 50 m
4 mm
200 V / 3~:
up to 10 m
3.5 mm
10 m to 30 m
5.5 mm
Connection to the power supply socket
Before connection to the power supply,
check that the machine is switched off –
see "Switching off the machine"
Swivel the lower holder upward and
N
remove the power cord
Plug the power cord or extension
N
cord into a properly installed outlet

Switching On

2
NOTICE
2
The machine may only be switched on
when the water intake hose is connected
2
and the water supply has been turned
on. Otherwise the machine may be
damaged due to lack of water.
2
Turn on water supply
N
2
Completely unroll the high-pressure
N
hose
Turn the master switch to I – now
N
the machine is in standby mode
Machine with hose reel
NOTICE
Always completely unroll the high-
pressure hose from the hose reel. The
high water pressure causes the high-
pressure hose to expand. This can also
damage the hose reel or high-pressure
hose.
English
45

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Re 462Re 362 plusRe 462 plus

Tabla de contenido