Battery Installation Or Replacement - KPS TC20 Manual De Funcionamiento

KPS-TC20 • Non-contact digital tachometer
Press plus or minus key to select storage number. At this time, if you press
the backlight key, the rotation speed value will flash. Thus, you can read and
display the value in the current storage number. It can exit the storage state by
pressing the MEM key in the storage state.
8.

BATTERY INSTALLATION OR REPLACEMENT

The power supply used by this meter is four 1.5V SIZE AAA batteries. To re-
place batteries, open battery cover, remove the old batteries, install new bat-
teries of the correct size, according to the illustration on the cover. Close the
battery cover after installation, and tighten screw before using the Meter.
15