Switching Frequency Or Duty - KPS -PA60 Manual De Funcionamiento

KPS-PA60 • Digital clamp meter
6) OL triggering: Under RELΔ mode, OL shows when input value larger than
the allowed value of the measurement mode. Press the key again, the relative
measurement function will be cancelled. Disable to enter RELΔ mode when
OL shows.
7) No analog section bar function under RELΔ mode.

4.3 Switching frequency or duty

• During working at the voltage or current ranges, press the "Hz/%" button one
time, frequency of the voltage or current will be measured. Press the "Hz/%"
button twice, the meter will be changed into the duty range for measuring the
duty cycle of the voltage or current. At the same time, the meter is changed
into manual mode.
• Press the "Hz/%" button again, meter will be back to the condition of the
voltage or current measuring.
NOTE:
During working at maximum or minimum value measuring function, the meter
can‟t be changed into frequency or duty cycle measuring mode.
4.4 Switching manual or auto mode
Range key is the Auto/Manual measurement key that acts with trigger. Auto
measurement is pre-set as power-on, and switches to Manual measurement
when the key is pressed one time. In Manual measurement mode, mode will
move upward upon each press to the highest mode, then return to the lowest
mode as a loop. If press the key over 2 seconds, the system will switch back
to Auto measurement status.
4.5 Switching functions
1) FUNC Key is a function selection key that acts with trigger. Press the key
can choose the needed measurement mode: To choose DC or AC in DC/AC
status, to choose Diode or Buzzer in Diode/Buzzer status, to choose Ohm,
Cap, Diode or Buzzer in Ohm/Cap/Diode/ Buzzer status.
2) Press the key then turn on the power, the Auto Power-off function will be
cancelled, the signal "
(Power-Off). Press the key then power on will have the Auto Power-Off func-
tion.
" disappears in LCD, and enter into Sleep Status
37