Switching Frequency Or Duty - KPS PA50 MINI Manual De Funcionamiento

Capacitance
Range Resolution
6,6mF 0,001mF
66mF 0,01mF
660mF 0,1mF
6,6mF 0,001mF
66mF 0,001mF
- Overload protection: 250V DC or rms AC
4. OPERATION INSTRUCTIONS
4.1 Holding readings
• Press the "HOLD/B.L" button to hold the readings while taking measurement
and the value on the display will be held.
• Press the "HOLD/B.L" button again to release the reading hold function.
4.2 Switching ranges
• When the meter is turned on, it is at the auto range mode for measuring cur-
rent, voltage, resistance, capacitance and frequency.
• Press the "RAN" button for manual range mode. The range will go up one
level at each press and return to the lowest level when the highest level is
reached.
• Press the "RAN" button for one or more seconds to return to the auto range.
• Press the "RAN" button to get back to normal test during working in maxi-
mum or minimum value measuring function.
Note:
At frequency range, meter can't be set to manual range mode.

4.3 Switching frequency or duty

• During working at the voltage or current ranges, press the "Hz/%" button one
time, frequency of the voltage or current will be measured. Press the "Hz/%"
button twice, the meter will be changed into the duty range for measuring the
duty cycle of the voltage or current. At the same time, the meter is changed
into manual mode.
KPS-PA50 MINI • Digital clamp meter
Accuracy
Lecture <2mF ± (4,0% of reading
+ 5 digits)
± (4,0% of reading + 3 digits)
38