Technical Specifications; General; Characteristics; Dc Voltages - Metrix MX 24B Manual De Instrucciones

Chapter II
5.

TECHNICAL SPECIFICATIONS

5.1.

General

Only the values assigned tolerances or given limits are guaranteed values. Values without
tolerances are given for information only, without guarantee (standard NFC 42670). The
measurement errors must be considered in an environment of reference temperature
(refer to § 5.2.11).
It is essential that all measuring instruments are regularly calibrated.
5.2.

Characteristics

Accuracy is ± [% reading (R) + number of digits (D)].
{Accuracy : ''n %R + n D'' means ''n % of the reading + n digits'' }

5.2.1. DC voltages

Selector switch
position
ADP
DC
V
DC
(∗) Acceptance permanent max. voltage
Number of points :
Range selection :
Common mode rejection (500 mV range) :
Serial mode rejection :
Intermittent signal sounds and « OL » on the display in case of range overpassing.

5.2.2. AC voltages (AC and AC+DC)

Selector switch
position
V
LOW Z
ADP
AC+DC
V
AC+DC
(∗) Acceptance permanent max. voltage
Specifications applicable from 5 % to 100 % of the range for a sinusoidal signal in band
40 Hz to 1 kHz.
Number of points :
Range selection :
Common mode rejection :
Additional error according to crest factor :
Intermittent signal sounds and « OL » on the display in case of range overpassing.
5000-count portable digital multimeter, with current input
Ranges
Accuracy
500 mV
DC
5 V
DC
50 V 0,3 %R + 2 D
DC
500 V
DC
1000 V
DC
Ranges Accuracy
40 Hz to 1 kHz
5 V
AC
50 V 1 %R + 2 D
AC
500 V
AC
600 V
AC
500 mV 1.5 %R + 3 D
AC+DC
5 V
AC+DC
50 V 1.5 %R + 2 D
AC+DC
500 V
AC+DC
750 V
AC+DC
Input impedance
Protection
± 600 V
10 MΩ
11 MΩ
± 1100 V
10 MΩ
5 000
automatic or manual for the 5 V, 50 V,
500 V, 1000 V ranges
at 50 and 60 Hz, better than 120 dB
at 50 and 60 Hz, better than 60 dB
Input Protection
impedance
± 600 V
500 kΩ
± 600 V
10 MΩ // 100 pF
11 MΩ // 100 pF
± 1100 V
10 MΩ // 100 pF
5 000
automatic or manual for the 5 V, 50 V,
500 V, 600 or 750 V ranges
at 50 and 60 Hz, better than 60 dB
1 % for a crest factor of 1.5 to 2
4 % for a crest factor of 2 to 3
Resolution
(∗)
0.1 mV
RMS DC
1 mV
DC
10 mV
DC
PEAK
100 mV
DC
1 V
DC
Resolution
(∗)
1 mV
AC
10 mV
RMS AC
100 mV
AC
1 V
AC
0.1 mV
AC+DC
RMS
1 mV
AC+DC
10 mV
PEAK AC+DC
100 mV
AC+DC
1 V
AC+DC
23