Darning Plate; Changing The Presser Foot; Detaching And Attaching The Foot Holder - ALFA COMPAKT 500E Manual De Instrucciones

q
w
q
q
e
q
w
r
e
w
r
10

Darning Plate

To attach:
Position the darning plate with 3 pins on the bottom.
Fit the darning plate pins into the needle plate holes.
q Pin
w Hole
To remove:
Lift the front edge of the darning plate to remove.
NOTE:
Remove the darning plate when opening the hook
cover plate.

Changing the Presser Foot

CAUTION:
Turn OFF the power switch before changing the foot.
Always use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
Do not push the lever down to prevent it from being
broken.
To snap off:
Raise the needle and presser foot.
Press the lever on the back of the foot holder and the
foot will drop.
q Lever
To snap on:
Place the presser foot so the pin on the foot lies just
under the groove of the foot holder.
Lower the foot holder to lock the foot in place.
w Groove
e Pin
Each foot is marked with a letter for identification.
r
Identification Letter

Detaching and Attaching the Foot Holder

WARNING:
Turn OFF the power switch before detaching or
attaching the foot holder.
To detach:
Raise the presser bar and turn the setscrew
counterclockwise to remove the foot holder.
q Setscrew
w Foot holder
To attach:
Align the hole in the foot holder with the threaded
hole in the presser bar and insert the setscrew
through the hole.
Tighten the setscrew by turning it clockwise.
e Hole
r Threaded hole