Troubleshooting - Reliable Steamboy T1 Manual De Instrucciones

TROUbLESHOOTING

CAUTION: Prior to troubleshooting isolate the unit by removing the cord from the
power socket.
PRObLEM
LED is not on
No Steam
Pale residue left on the floor
(Caused by leaving the floor
steamer in the same position
for too long)
Too much water on the floor
07
REMEDy
1. Ensure Steamer power cord is correctly plugged
into power outlet.
2. Ensure circuit breaker is operational.
3. Try operating the steamer from another
power outlet.
1. Ensure the water tank has correct level of water.
1. Can be removed with household white vinegar
or a decalcifying product.
2. Alternatively reheat the area for one minute and
residue should be removed. CAUTION: DO NOT
OVERHEAT AREA.
1. Hold steam switch for no longer than 8 seconds at
a time. Release the switch for a few seconds and
then you can repeat (the heating element needs
time to heat up again to properly convert the water
into steam.