Height Adjustment Knob Installation - Delta ShopMaster Manual De Instrucciones

FENCE RAIL
Attach fence rail (N), scale side up (16" side of scale to the
right), to the front of the saw using (4) M5 x 25mm hex socket
cap screws (i) as shown in Fig. 2, making sure rail is properly
seated on each rail support on the front of the table.
HEIGHT ADJUSTMENT KNOB
INSTALLATION
• Insert shoulder screw (c) into height adjustment knob (d)
as shown in (Fig. 3).
• Tighten shoulder screw (c) with Phillips Screw driver into
Hand Wheel. Height adjustment knob should rotate freely
around shoulder screw when raising or lowering the blade
with the Height Adjustment Hand Wheel.
ASSEMBLY
b
N
c
11
RAIL SUPPORT
Figure 2
d
Figure 3