AFG 3.1AT Manual Del Propietário página 12

3°1AT ASSEMBLY STEP 1
HARDWARE FOR STEP 1 :
BOLT (A)
20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
ARC WASHER (C)
8.2 mm
Qty: 6
R GHT CONSOLE MAST_ //
/ '
/
// /
/
/
// /
// //
LEAD WIRE
MAIN FRAME BOOT
-%.
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
* This step is for 3.1AT models only.
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
B Open HARDWARE FOR STEP 1.
C
Slide MAIN FRAME BOOT up CONSOLE MAST.
Pull LEAD WIRE through RIGHT CONSOLE MAST.
After pulling the LEAD WIRE through the mast, the
top of the CONSOLE CABLE should be located at
the top of the mast. Detach and discard LEAD WIRE.
NOTE: D0not pinch cons0!e cab!e whe n placing
the mast onto the main frame bracket.
Place RIGHT CONSOLE MAST over MAIN FRAME
BRACKET.
Attach CONSOLE MAST to MAIN FRAME
BRACKET using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC WASHERS (C).
NOTE: Do not tighten bolts until step 3 is completel
F Repeat steps D-E to attach LEFT CONSOLE MAST.