Turning The Power On; Turning The Power Off; Auto Power-Off Function - ARP 2600 FS Manual Del Usuario

Turning the power on

Turn off the power of your powered monitor speakers or other external output
device before you power-on the ARP 2600 FS.
1.
Lower this unit's LEFT SPEAKER slider and RIGHT SPEAKER slider to the
minimum position.
2.
When you turn this unit's power switch ON, the power supply LED is lit, and
the power turns on. Lower the volume of your powered monitors or other
external output equipment before you turn the power on.
3.
Adjust this unit's LEFT SPEAKER slider and RIGHT SPEAKER slider. If
external output equipment is connected, raise the volume of that equipment as
appropriate.
If you are not familiar with how to create sounds, we suggest that you now
Tip:
adjust the settings as described in the "Basic settings" section.

Turning the power off

1.
Lower the volume of your powered monitors or external output system, and
turn their power off.
2.
When you set this unit's power switch to the STANDBY position, the power
supply LED goes dark, and the power turns off.

Auto power-off function

The ARP 2600 FS has an auto power-off function that automatically turns the power
off when approximately four hours have elapsed since the instrument was last
played or used. With the factory settings, the auto power-off function is enabled.
Changing the auto power-off setting
If desired, you can enable or disable the auto power-off function.
Disabling the auto power-off function
On side panel L, set MODE SWITCH 5 off (downward
position). The auto power-off function is disabled; you don't
have to turn the power off and on again to apply the setting.
Enabling the auto power-off function
On side panel L, set MODE SWITCH 5 on (upward position).
The auto power-off function is enabled; you don't have to turn
the power off and on again to apply the setting.
ON
1 2 3 4 5
ON
1 2 3 4 5
- 21 -