Front Panel (Vco-1 Section) - ARP 2600 FS Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Front panel (VCO-1 section)

INITIAL OSCILLATOR FREQUENCY
INITIAL OSCILLATOR FREQUENCY
a
b
k
l
j
i
h
g
c
d
e
f
VCO-1 (Voltage Controlled Oscilator 1)
a . INITIAL OSCILLATOR FREQUENCY slider . . . . . . . . . . . . . . . . . . .[10( .03)Hz...10K(30 .)Hz]
Broadly adjusts the VCO-1 pitch.
The frequency range is an approximate value.
b . FINE TUNE slider
Finely adjusts the VCO-1 pitch.
c . CV input 1 jack
This is the pitch CV input jack for VCO-1. The KBD CV is internally connected.
d . CV input 2 jack
This is the pitch CV input jack for VCO-1. The S/H OUT is internally connected.
e . CV input 3 jack
This is the pitch CV input jack for VCO-1. The ADSR is internally connected.
f . CV input 4 jack
This is the pitch CV input jack for VCO-1. The sine wave of VCO-2 is internally
connected.
g . AUDIO/LF select switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [KBD ON, KBD OFF]
Selects whether to use VCO-1 as an audio signal or as an LFO. When used as an
LFO (KBD OFF), the CV from the keyboard is no longer input to VCO-1.
h . CV input 2 slider
Adjusts the signal level of VCO-1 CV input 2.
i . CV input 3 slider
Adjusts the signal level of VCO-1 CV input 3.
j . CV input 4 slider
Adjusts the signal level of VCO-1 CV input 4.
k . SAWTOOTH output jack
Outputs the sawtooth wave of VCO-1.
l . SQUARE output jack
Outputs the square wave of VCO-1.
- 7 -

Publicidad

Tabla de contenido

Solución de problemas

loading

Productos relacionados para ARP 2600 FS

Tabla de contenido