Front Panel (Vco-3 Section) - ARP 2600 FS Manual Del Usuario

Front panel (VCO-3 section)

INITIAL OSCILLATOR FREQUENCY INITIAL OSCILLATOR FREQUENCY
d e
a
b
c
l
m
k
j
i
h
f g
VCO-3 (Voltage Controlled Oscilator 3)
a . INITIAL OSCILLATOR FREQUENCY slider . . . . . . . . . . . . . . . . . . .[10( .03)Hz...10K(30 .)Hz]
Broadly adjusts the VCO-3 pitch.
The frequency range is an approximate value.
b . FINE TUNE slider
Finely adjusts the VCO-3 pitch.
c . PULSE WIDTH slider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [10%...90%]
Adjusts the duty cycle of the VCO-3 pulse wave.
d . CV input 1 jack
This is the pitch CV input jack for VCO-3. The KBD CV is internally connected.
e . CV input 2 jack
This is the pitch CV input jack for VCO-3. The noise generator is internally
connected.
f . CV input 3 jack
This is the pitch CV input jack for VCO-3. The ADSR is internally connected.
g . CV input 4 jack
This is the pitch CV input jack for VCO-3. The sine wave of VCO-2 is internally
connected.
h . AUDIO/LF select switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [KBD ON, KBD OFF]
Selects whether to use VCO-3 as an audio signal or as an LFO. When used as an
LFO (KBD OFF), the CV from the keyboard is no longer input to VCO-3.
i . CV input level 2 slider
Adjusts the signal level of VCO-3 CV input 2.
j . CV input level 3 slider
Adjusts the signal level of VCO-3 CV input 3.
k . CV input level 4 slider
Adjusts the signal level of VCO-3 CV input 4.
l . SAWTOOTH output jack
Outputs the sawtooth wave of VCO-3.
m . PULSE output jack
Outputs the pulse wave of VCO-3.
- 9 -