Stihl HSA 65 Manual De Instrucciones página 26

English
Always remove the battery before carrying out any work on the power tool.
Condition
Running time is too short
Battery jams when being inserted in power
tool / charger
Battery is not charging even though the light
emitting diode on the charger lights up green
Light emitting diode on charger flashes red
1)
STIHL recommends a STIHL servicing dealer.
24
Cause
Battery is not fully charged
Life of battery has been reached or
exceeded
Blades sticking / dirty
Guides dirty
Battery too hot / too cold
(1 light emitting diode on battery lights
up red)
No electrical contact between charger
and battery
Battery faulty
(4 light emitting diodes on battery flash
red for about 5 seconds)
Charger faulty
Remedy
Charge the battery
1)
Check battery and replace
Clean the blades and spray them with
STIHL resin solvent
Carefully clean the guides
Allow battery to cool down / Warm up
battery slowly at a temperature of 60°F
to 70°F (15°C–20°C).
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between 40°F (5°C) and 105°F (5°C–
40°C).
Remove the battery and refit it properly
1)
Install new battery
Have charger checked by servicing
1)
dealer
HSA 65