Stihl HSA 65 Manual De Instrucciones página 8

English
Warning!
Never bridge (short circuit) the battery
terminals with metallic objects, since
this may damage the battery and possi-
bly cause a fire. Keep a battery that is
not in use away from metal objects (e.g.
nails, coins, jewelry). Do not use metal
containers for transporting batteries.
Store the battery out of reach of children
in a cool and dry area away from direct
sunlight and excess heat or cold (14 °F
– 122 °F (-10 °C – +50 °C)).
Charger
Use only original STIHL chargers.
Use only for charging matching STIHL
type AP batteries with a maximum
capacity of 10 Ah and a maximum
voltage of 42 V.
Never charge defective, leaking or
deformed batteries.
Connect the charger only to a power
supply with the voltage and frequency
specified on the rating plate. Always
connect the charger to a properly
installed wall outlet.
Never use a charger with damaged
housing, damaged power supply cord or
damaged plug. Do not operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in
any way.
Do not open or dissassemble charger –
no user serviceable parts inside.
Store charger out of the reach of
children.
6
Protect the charger from
rain and dampness. Keep
charger dry.
Use and store charger
only indoors in dry rooms.
Operate charger at temperatures
between 41 °F (5 °C) and 104 °F
(40 °C).
Allow the charger to cool down normally
– do not cover it.
Never bridge the contacts of the charger
with metallic objects (e.g. nails, coins,
jewelry) – short circuit. The charger may
be damaged by a short circuit.
In the event of smoke or fire in the
charger, disconnect it from outlet
immediately.
Warning!
To reduce the risk of electric shock or
short circuit, do not insert any objects
into the charger's cooling slots.
Warning!
The charger heats up during the charg-
ing process. Do not operate on an easily
combustible surface (e.g. paper, texiles)
or in an easily combustible environment
– risk of fire.
Warning!
Do not operate in a hazardous location,
i.e. in a location where there are com-
bustible liquids (fumes), vapors or
dusts. Chargers can produce sparks,
which may ignite the dust or vapors –
risk of explosion.
Check the charger's
power supply cord and
plug regularly for dam-
age. If the power supply
cord or plug is damaged,
immediately disconnect
the plug from the wall
outlet to avoid the risk of
electric shock.
Never jerk the power supply cord to
disconnect it from the wall outlet. To
unplug, grasp the plug, not the cord.
Have a damaged power supply cord
repaired by an experienced electrician.
Do not use the power supply cord for
any other purpose, e.g. for carrying or
hanging up the charger.
Never use power supply cords that do
not comply with regulations.
Make sure the power supply cord is
located and/or marked so that it will not
be stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise be subjected to
damage or stress.
An extension cord should not be used
unless absolutely necessary. If an
extension cord must be used, plug the
charger into a properly wired 16 gauge
(AWG 16) or heavier gauge extension
HSA 65