Advanced Functions - SOMFY Sunea io Guia De Instalacion

Sunea io
Readjusting the lower end limit
1) Set the awning to the lower end limit.
2) Press the Up and Down buttons simultaneously until
the awning makes a movement: the motor is in setting
mode.
3) Adjust the lower position of the awning using the Up or
Down button.
4) Press the "my" button until the awning makes a movement:
the new lower end limit has been programmed.

7.4. Advanced functions

Contact the awning's manufacturer before using these functions to check the compatibility of your
systems.
7.4.1 "Back impulse" function
This function allows you to tighten the fabric each time the awning is lowered. It is possible to adjust
it until turn of roller tube.
To activate this function:
1) Set the awning to the lower end limit.
2) Press the «my» and Up buttons simultaneously until the
awning makes a movement : the motor is in programming
mode.
3) Adjust the fabric's tension using the Up or Down buttons
( turn of tube max).
4) Press the "my" button until the awning makes a
movement: the fabric's tension has been programmed.
7.4.2. "Back release" function on cassette awnings only
This function allows the fabric tension to be released after the cassette awning is closed.
The procedure for activating and deactivating the "Back release" function is the same.
For safety reasons, this function can only be activated or deactivated by the Somfy io control point in
3 situations:
• After the settings confirmation and before programming the first Somfy io control point.
• After programming the first Somfy io control point and during the next 4 cycles.
• After a single power outage and during the next 4 cycles.
To activate this function :
1) Set the awning to the upper end limit .
2) Press the «my» and Down buttons simultaneously until
the awning makes a movement.
If the "Back release" function was inactive, it is activated.
If the "Back release" function was active, it is deactivated.
7.4.3. "Closing force" function on cassette awnings only
This function allows the closing force of the awning cassette to be increased or decreased to 3 levels
(high/medium/low).
The motor is factory set at the medium level.
For safety reasons, this function can only be accessed via the Somfy io control point in 3 situations:
• After the settings confirmation and before programming the first Somfy io control point.
• After programming the first Somfy io control point and during the next 4 cycles.
• After a single power outage and during the next 4 cycles.
8
1
3
or
1
3
or
1
Copyright © 2010 Somfy SAS. All rights reserved.
2
4
2
4
2