Assembly And Adjustments; Folding And Unfolding; Legrests; Angle-Adjustable Foot Plates - B+B Pyro Start Plus Manual De Instrucciones

PYRO START PLUS / SL

4. Assembly and adjustments

You can carry out the adjustments of your wheelchair yourself with a
little manual dexterity. You need a set of 5 mm to 8 mm Allen keys and
ring spanners, SW10 and SW13. If you have any queries, please contact
your mobility dealer.
2

4.1. Folding and unfolding

Delivery
Your new B+B wheelchair is delivered fully assembled and folded in an
original B+B box.
3
To avoid damage during transport, plug-in attachable parts are
delivered under separate packaging (see fig. 2).
Unfolding
Place your wheelchair next to you. Tip it towards you until the load is
taken off one drive wheel (see fig. 3).
4
Now press on the seat tube nearest to you with the flat of your hand so
as to unfold the wheelchair (see fig. 4).
13
| Lightweight wheelchair
Please be careful of your fingers when making
adjustments. Risk of entrapment!
When unfolding, please make sure your fingers
remain on the seat belt. Otherwise there is a risk
of trapping them!
Lightweight wheelchair |
Folding
Place your B+B wheelchair next to you. Tip it by pulling the backrest
towards you, until the load is taken off the opposite drive wheel.
At the same time, pull the seat cushion upwards until the chair is
completely folded (see fig. 6).
To avoid injuries, do not hold the wheelchair at the
armrest while tilting If legrests are fitted, the foot
plates should first be folded up.

4.2. Legrests

4.2.1 Legrests with foot plate
Both legrests are supplied with the foot plates fitted. The foot plates on
both legrests can be folded upwards in the sitting position.

4.2.2 Angle-adjustable foot plates

The angle of the foot plates can be adjusted:
• To do so, unscrew the Allen screw (see fig. 8). Adjust the foot plate
to the required position by rotating the toothed ring.
• Tighten the Allen screw (see fig. 8) again.
Bischoff & Bischoff GmbH | 12.02.2020
PYRO START PLUS / SL
5
6
7
8
14