Control Unit; Seatbelt; Using The Wheelchair; Description Of The Control Functions - B+B Neo XXL Manual De Instrucciones

Neo XXL
| Electric Wheelchair

3.5.6. Control unit

The control unit can be mounted either on the right or left-hand side
underneath the armrest each.
• Loosen the lever screw under the armrest (fig. 13).
• Fit the control unit under the opposite armrest. To do this, re-
tighten the lever screw.
13

3.5.7. Seatbelt

The seatbelt is attached to the side of the backrest.
• Adjust the length of the seatbelt by positioning the buckle
accordingly (fig. 21).
• Fasten the seatbelt with the latch.
• Open the seatbelt by pushing the red button at the latch.
14
58
Please note that the control unit cables must be
relaid. Get a qualified person to do this.
Electric Wheelchair |

4. Using the wheelchair

After adjusting the wheelchair to your personal needs, familiarize
yourself with the control functions.
4.1. Description of the control
functions
If the wheelchair is ordered without electrical adjustments for backrest,
seat tilt and knee angle, the VR-2 controller from PG Drives Technology
is fitted. Subsequent retrofitting with electrical adjustment components
is possible, but requires adaptation by an authorised service engineer.
If the wheelchair is ordered with electrical adjustments for backrest,
seat tilt and/or knee angle, the R-net controller from PG Drives
Technology is fitted. The functions of both joystick controllers are
described separately below

4.1.1. VR-2 control

Control panel
15
Bischoff & Bischoff GmbH | 01.06.2019
Neo XXL
Charge and
programming jack
59