Setting To Work - Connection To The Power Supply; Warning Labels; Extensions; Dry Applications - Nilfisk VHS110 Z22 Serie Manual De Instrucciones

VHS110 Z22
Setting to work - connection to the power
supply
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection
cables must be protected against splashed water.
Make sure that connections to the electrical mains
■
and plug are correct.
■ Use the vacuum cleaner only when the cord that
connect to the electrical mains are in perfect
condition (damaged cords could lead to electric
shocks!).
■ Regularly check that the electric cable does not
show signs of damage, excessive wear, cracks or
ageing.
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
■ Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■ Only replace the electric power cable with one of
the same type as the original: H07 RN - F.
The cable must be replaced by the manufacturer's
■
Service Center staff or by equivalent qualified
personnel.

Warning labels

GB
Labels:
1. Warning: Using an appropriate tester, check the
grounding continuity between the plug ground pin and
the final suction accessory
2. Caution: Don't open while the voltage is applied
C421
WARNING!
WARNING!
Figure 3

Extensions

Extension cords are not allowed within a classified zone
unless marked accordingly.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 ms or an equivalent protection circuit.
In case the socket that the vacuum cleaner is
connected to could exceed 1000 V in case of a surge
generated by a lightning, the user shall provide the
appropriate protection
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons and could short circuit the
power supply.

Dry applications

The supplied filters must be installed correctly as explained
in section "Primary star filter replacement"
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner from its power source
before cleaning, servicing or replacing parts; the plug
must be removed from the socket.
■ Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately make the EC Declaration of conformity
issued with the vacuum cleaner void.
WARNING!
Contact the manufacturer's technical service or sales
network for maintenance operations not described in
this manual.
6
[ NOTE ]
11/2016