Functional Description - Makita 9032 Manual De Instrucciones

8. Keep hands away from rotating parts.
9. Do not leave the tool running. Operate the tool
only when hand-held.
10. This tool has not been waterproofed, so do not
use water on the workpiece surface.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
Class II Construction
･
meter per second
･
feet per minute

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting arm inclination
The arm can be pivoted and fixed at any desired angle
within the "A" range according to the operating position
or the figure of the workpiece.
1
USD204-3
001215
Loosen the lock lever by raising it. Pivot the arm to the
desired position, and secure the lock lever to fix the arm
firmly.
Replacing arm
By replacing the standard-equipped arm by optional one,
6 mm (1/4") or 13 mm (1/2") width belt can be used.
Remove the arm by loosening the screw that secures the
arm. Insert the arm that fits the belt to be used, and
tighten the screw firmly.
1
001216
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
4
1. Lock lever
2
2. Arm
"A" range
1. Screw
2. Arm
2