Makita 9032 Manual De Instrucciones página 5

1
2
001217
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial
1
001218
The belt speed can be infinitely adjusted between 5 m
and 28 m per second (980 - 5600 ft./min.) by turning the
speed adjusting dial to a given number setting from 1 to 6.
Higher speed is obtained when the dial is turned in the
direction of number 6; lower speed is obtained when it is
turned in the direction of number 1. Select the proper
speed for the workpiece to be sanded.
CAUTION:
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or the
speed adjusting function may no longer work.
1. Lock button
2. Switch trigger
1. Speed adjusting
dial
5
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing abrasive belt
3
4
001219
Pull the cam lever all the way out. Install the belt over the
rear pulley, and slip the belt over the front pulley, with the
belt pulled out to the front arm. Return the cam lever to
the original position.
Adjusting belt tracking
1
2
001220
Switch on the tool and make sure that the belt is aligned
properly.
Use the adjusting dial to center the belt tracking. Turn the
adjusting dial clockwise to incline the arm to the right, or
counterclockwise to incline it to the left.
Connecting to Makita vacuum cleaner or dust
collector
1
2
3
4
001221
1. Arm
1
2. Abrasive belt
3. Cam lever
4. Rear pulley
2
1. Arm
2. Adjusting dial
1. Dust nozzle
2. Hose 28
3. Hose of vacuum
cleaner
4. Vacuum cleaner