Replacing Carbon Brushes - Makita 9032 Manual De Instrucciones

CAUTION:
Always close the nozzle cap when the vacuum
•
cleaner/dust collector is not connected to the
nozzle. Never insert your finger into the nozzle.
Cleaner sanding operations can be performed by
connecting the belt sander to Makita vacuum cleaner or
dust collector.
Open the nozzle cap, and install the dust nozzle.
Connect the hose of a vacuum cleaner/dust collector to
the dust nozzle.
When connecting to Makita vacuum cleaner, an optional
hose 28 mm (1-1/8") in inner diameter is necessary.
When connecting to Makita dust collector, connect the
hose of the dust collector directly to the dust nozzle.
1
2
3
001222
OPERATION
CAUTION:
Secure the workpiece with clamps, etc. if there is
•
any possibility of it moving during the work
operations.
The tool should not already be in contact with the
•
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish, damage to the belt
of loss of control of the tool may result.
When working with the tool, be very careful to avoid
•
any contact of the tool and belt with any part of your
body or anyone or anything near you.
Hold the tool firmly with both hands. Turn the tool on and
wait until it attains full speed. Gently apply the tool to the
workpiece surface and move the tool forward and back.
Press the belt only lightly on the workpiece. Excessive
pressure may damage the belt and shorten tool life.
Always use "A" range of the belt to sand the workpiece.
"A" range
001223
1. Dust nozzle
2. Hose 28
3. Dust collector
1. Flat shoe
1
001224
001225
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
6
1. Limit mark
1