REBER 9340 N Manual De Uso página 106

145 - 155 micron
INFO:
Sealing time could be different using different kind of bags even if thickness is the same;
we suggest to test welding after changing welding time.
IMPORTANT
If the machine is not used for a long period and/or in the case of non-adequate or low
temperatures, it is recommendable, before using the machine, to try it once without using
the bag and keep the machine working in vacuum conditons for some seconds.
USAGE INSTRUCTIONS
AUTOMATIC USE
1) Put the food which is to be vacuum preserved in a bag of adeguate size, leaving about 5
cm from the edge of the bag and the food.
2) Lift the cover up (4).
3) Place the open side of vacuum bag in the vacuum chamber (6), between the gaskets
(5). 4) Close the cover and press pump switch (1). This will start vacuum operation –
green LED will light on (11) to show vacuum operation is on, red LED (12) will light on
for few seconds to show the user that the machine is operating in automatic mode.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it
sticks to the surface of the bag. After a few seconds the depression created by the pump
will permit to release the cover, while the machine will keep on suction.
Red LED will light on when food preservation vacuum level is reached, and welding
operation will start few seconds later. Red LED will flash during welding operation and
lights off at the end.
USER INTERVENTION
Every operation will stop when pressing pump switch (1).
User can start welding operation, by pressing welding switch (2), during vacuum operation.
User can change from automatic to manual use, during vacuum operation, by pressing and
holding pump switch (2); in this case welding operation should be manually operated by
pressing welding switch (2).
MANUAL USE
1) Put the food which is to be vacuum preserved in a bag of adeguate size, leaving about 5
cm from the edge of the bag and the food.
2) Lift the cover up (4).
3) Place the open side of vacuum bag in the vacuum chamber (6), between the gaskets
(5). 4) Close the cover and press pump switch (1). This will start vacuum operation –
green LED will light on (11) to show vacuum operation is on.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it
sticks to the surface of the bag. After a few seconds the depression created by the pump
will permit to release the cover, while the machine will keep on suction.
6) Red LED will light on when food preservation vacuum level is reached.
7) Press welding switch (2) to start welding operation; red LED (12) will flash to show
welding operation is on. Machine will stop and LEDs will light off at the end of the
welding time.
N.B.: Welding operation can be starter at any time during vacuum operation by pressing
welding switch (2), even if red LED (12) is off.
END OF OPERATION
At the end of vacuum/welding operation unplug the machine.
8 / 9
106