REBER 9340 N Manual De Uso página 93

Clean the vacuum chamber in case of aspiration of liquid or powder
with normal cleaner for plastic material, be careful to let the vacuum
chamber dry after cleaning.
" Only for U.S.A. use" To reduce risks of electric shock, this product
has a polarized plug ( one blade is wider than the other). This plug is
intended to fit in a polarized outlet only one way. When the plug
does not fit fully in the outlet, reverse the plug. When it still does not
fit, contact a qualified electrician to install the proper outlet. Do not
change the plug in any way.
Close supervision is required when this product is used near
children.
Products in powder or grains shall be covered with a cloth before
-
being vacuum-packaged, so that they are not sucked into the
vacuum chamber and do not obstruct the valve.
Containers unsuitable for vacuum packaging can implode through
-
the effect of air pressure and cause damages and injuries. In case
of storage in freezers, only special containers in toughened glass
shall be used.
The air pump and the welding system are equipped with thermal
-
protection: in case of overheating the unit stops automatically and
can resume work after some minutes. - Experience and practice
will enable you to obtain the best results with each product.
Wrinkles and creases on the bag surface can prevent the package
-
from reaching a satisfactory vacuum level as a small air quantity
can be sucked through them. To avoid such inconveniences, place
the bag in spread conditions within the vacuum chamber.
Adjustments related to automatic operation are carried out in the
-
factory in order to offer the best performances, both as for safety
and reliability. Should different performances be required in
particular cases, operate the unit manually.
If you have not waited for the minimum time prescribed between
-
connection to network and cycle starting, act as follows: unplug,
plug again and wait as long as required.
When containers are used particular attention should be paid to
-
welding bar heating (7.) to prevent burns.
For safety reasons, we recommend to operate manually when
-
containers are used and the vacuum gauge pointer (3.) reaches
the limit of the yellow area.
93