Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr JIG SAWS
WArNING:
(GAINED FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT
SAFETY rULES. If you use this tool unsafe or incorrectly, you can suffer serious
personal injury!
• Hold the tool by insulated gripping surfaces
may contact hidden wiring. Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator.
• Avoid cutting nails,
• Do not cut hollow pipe.
• Check for the proper clearance
strike the floor, work bench, and etc.
• Make sure the blade is NOT contacting the workpiece
• Do not leave the tool running.
• Do not touch the blade or the workpiece immediately after operation.
be extremely hot and could burn your skin.
• Always switch off and wait for the blade to come to a complete stop
removing from the workpiece.
• Keep hands away from the moving parts.
• Some material contains chemicals which may be toxic.
inhalation and skin contact. follow material supplier safety data.
• Always hold the tool firmly in your hands
• Wear eye and hearing protection.
otherwise specified, everyday glasses provide only limited impact resistance, they are not safety glasses.
use only certified safety equipment; eye protection equipment should comply with ANSI z87.1 standards.
Protective hearing equipment should comply with ANSI s3.19 standards.
• Protect your lungs.
the risk of personal injury.
WArNING:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFOrT Or FAMILIArITY WITH PrODUCT
inspect workpiece for any nails and remove them before operation.
beyond the workpiece before cutting so that the blade will not
Operate the tool only when hand-held.
Wear a face or dust mask if the operation is dusty. following this rule will reduce
read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
when performing an operation where the tool
before switching the tool "ON".
Always use safety glasses with side shields. unless
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
before the switch is turned on.
It may
before
Take caution to prevent dust
5
Publicidad
Tabla de contenido
