Bosch VLH 2155 Manual De Usuario página 35

3.5.4 Fitting limit switch
Control column:
1. Guide switch rod (3) into the metal holder (1) under-
neath the regulating rod (2).
Fig. 25: Engaging switch rod
1 Metal holder
2 Regulating rod
3 Switch rod
4 Limit switch
Secondary column:
2. Screw on the switch rod at the secondary column.
Fig. 26: Screwing on switch rod
1 Switch rod
2 Bolt
!
The switch rod must be able to rotate.
Do not tighten.
Robert Bosch GmbH
Installation | VLH 2155 | 35
3.5.5 Fitting support arms
1. Set down the support arms in front of the corres-
ponding fitting positions at the lifting carriage.
i
Assignment of support arms: Refer to Section 6.
!
Pay attention to the positioning of the arms. The foot
protection mounts must be on the outside.
2. Lubricate the pin and the openings at the support
arm and lifting carriage with lithium grease.
3. Place the support arm in position at the lifting
carriage and secure with the pin.
Fig. 27: Fitting support arms
1 Support arm locking mechanism
2 Ring gear
3 Pin
4 Support arm
4. Position the ring gear over the pin and secure
with 3 bolts.
5. Fit foot protection at each support arm. The foot
protection is inserted in the mount.
Fig. 28: Fitting foot protection
1 Foot protection mount
2 Foot protection
en
|
1 689 978 583 2017-07-14