AnyTone AT-D878UV Manual De Instrucciones página 90

Allows the setup of DTMF/5TONE/2TONE encode and decode for the
Analog channels.
Squelch mode
(10)
When the analog channel is set up for both CTCSS/DCS decoding and
optional signaling, you can set up the RX condition in this menu.
SQ: You can hear the call once the channel receive matched carrier.
CDT: You can hear the call when receive matched CTCSS/DCS signal.
TONE: You can hear the call when receives a matched signaling.
C&T: You can hear the call when receives a matched CTCSS/DCS and
matched signaling.
C|T: You can hear the call when receives a matched CTCSS/DCS or.
Band Width
(11)
Choose wide band or narrow band for the analog channel.
Reverse
(12)
When this function is enabled, the RX frequency, TX frequency and
CTCSS/DCS encode/decode will be reversed.
Busy Lock
(17)
Always: Always allows transmissions
RL: Will not allow transmit when receiving matched carrier but unmatched
CTCSS/DCS.
BU: Will not allow transmit when receiving matched carrier.
OWN ID
(19)
When the analog channel set up with optional signal, you can check the
radio ID number in this menu. The ID number should be set up in PC
software – Analog – Analog Address Book.
DTMF Enc
(20)
Set a DTMF ID as the default call ID for the current channel.
Press the PTT key to transmit the selected DTMF ID.
Edit the DTMF ID in Menu or with the PC programing software.
2Tone Enc
(21-22)
Set a 2Tone as the default call ID for the current channel.
Press the PTT key to transmit the selected 2Tone.
Edit the 2Tone in the PC programing software before it can be selected.
AT-D878UV Digital DMR and Analog UHF/VHF Two Way Radio
7. MAIN MENU FUNCTIONS
30