Change The Carbon Brush; Storaging; Cleaning; Disposal - HOLZMANN MASCHINEN KAP 305JL Manual De Instrucciones

15.3

Change the carbon brush

If your HOLZMANN KAP 305JL motor becomes loud or even does not start anymore, the carbon
brushes are probably worn.
Remove with a screwdriver the carbon brush cover (30). If the carbon brush is worn (<4mm) you
need to replace the 2 carbon brushes.
Memorize the direction of the carbon brushes when removing
them. Take care to insert the new brushes similarly.
Run the saw for 10 minutes in idle run. Release the accelerator
lever and observe the time interval required for the saw blade to
stop. If it takes long time to stop (~ 20 seconds), then the
electric saw blade brake does not work. Let the saw be checked by a professional.
15.4

Storaging

The machine never store outdoors!
Storage permitted only at temperatures between + 5 ° and + 40 ° C, with at + 40 ° C the
humidity must not be higher than 60%.
Store in a dry, clean place
15.5

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.6

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
HOLZMANN Maschinen GmbH
KAP 305JL
www.holzmann-maschinen.at
N O T I C E
MAINTENANCE
47