Resetting And Preparing For Registration; Resetting The Remote Control - Velux KLR 100 Manual Del Usuario

Resetting and preparing for registration

The skylight can be reset to its initial factory settings
and then be prepared for registration.
1
To reset the skylight, make sure that it has been closed
by inserting a pointed object in the skylight operator
cover hole marked A and pressing briefly.
2
When the skylight is closed, press with a pointed
object through the operator cover hole marked A for
at least 5 seconds. The skylight operator and other
electrical products connected to the skylight will run
briefly back and forth indicating that they are ready to
be registered.
Note: A reset removes the connection between the
skylight with its electrical products and all remote
controls. Therefore the products cannot be operated
until they have been registered in a remote control
again. To reinstate the connection between product
and remote control after reset, please refer to the
instructions in section Initial set-up.
64 VELUX
A
A
ENGLISH

Resetting the remote control

The remote control can be reset to its initial factory set-
tings if you want to delete all registered products and all
programming and start afresh.
1
Slide off the battery cover as shown.
B
2
Press the button on the right side of the remote control
with a pointed object for at least 5 seconds.
B
min 5 sec
3
Replace the battery cover.
4
Press
remote control.
The remote control has now been reset. To reinstate the
connection between remote control and products, please
refer to the instructions in section Initial set-up.
"Yes" to confirm that you want to reset the
ENGLISH
iNFoRmatioN
the remote control
will be reset.
Continue?
Yes No
VELUX 65