Assembly; Receipt And Storage; Positioning And Dimensions; Removal And Reassembly Of The Front Cover - Carel gaSteam 45 Manual Del Usuario

Fig. 2.a
1000 mm min. 1000 mm min.
(40 inch)
Fig. 2.b
Fig. 2.c

2. ASSEMBLY

2.1 Receipt and storage

• Check that the humidifi er is intact upon delivery and immediately notify the carrier, in writing, of any
damage that may be due to careless or improper transport;
• Move the humidifi er to the site of installation before removing it from the packaging, holding the neck
only from below the base;
• Open the cardboard box and pull out the humidifi er, remove the layer of protective material and move
the humidifi er from the pallet to the support surface, keeping it vertical at all times; only remove the
protective bag when installing the unit.

2.2 Positioning and dimensions

• For installation choose the most suitable position for the steam distribution, that is, the position that
minimises the length of the steam outlet pipe (see STEAM DISTRIBUTION). The unit has been desi-
gned for installation on a fl oor that must be able to support the weight of the unit in normal operating
conditions (see DIMENSIONS AND WEIGHTS).
• The metal casing of the humidifi er heats up during operation, and the top may reach temperatures of
over 50°C (122 °F); check that this does not cause any problems.
• Make sure the humidifi er is level, and that the minimum spaces are respected as indicated in Fig. 2.b,
to allow room for maintenance operations.
(40 inch)
WARNING: make sure that the cooling fan outlet grill is not blocked or covered.

2.3 Removal and reassembly of the front cover

To remove the front cover of the humidifi er, proceed as follows (Fig. 2.c):
1. open the side door A;
2. remove the screws (part V) using a screwdriver;
3. hold cover B by the sides, tilt it until it is released from the side supports, lift it around 2 centimetres
and remove it from the hooks on the side supports;
4. remove the cover.
To close the appliance, proceed as follows (Fig. 2.c):
1. slightly tilt cover B, slide it onto the hooks on the side supports at the base of the panel;
2. tilt the cover back to vertical, and lightly press it into the side supports;
3. fasten the locking screws using a screwdriver (part V);
4. close door A.
8 gaSteam HARDWARE +030220538 - rel. 1.4 - 22.01.2008