aldes Dee Fly Instrucciones De Montaje página 28

WALL MOUNTING (horizontal/vertical)
Prohibited assemblies
Horizontal wall mounting of the heat exchanger
• Compulsory option: Dee Fly floor-mounting kit. Plan for one kit per casing
(code 11023144)
• Compulsory option: condensate evacuation kit for horizontal wall mounting
• Feet mounted on each end of the casing using screws (supplied)
• Anti-vibration mounts are used to separate the motor from the wall to limit
the transmission of noise
• Install the condensate recovery
delivered with the condensate evacuation kit for horizontal wall mounting
(code 11023099)
• Screw in the condensate evacuation nozzle
Vertical mounting of the exchanger
• Compulsory option: Dee Fly floor-mounting kit.
Plan for one kit per casing (code 11023144)
• Feet mounted on each end of the casing using screws (supplied)
• Anti-vibration mounts are used to separate the motor from the wall to
limit the transmission of noise
• To allow for the evacuation of condensates, fit a T-piece and purge
plug to the exchanger evacuation
• Add the condensate evacuation kit for vertical wall mounting (code
11129790)
Prohibited assemblies
Be careful that the direction
28
tank as described in the instructions
Be careful that the direction
of the exchanger and motor
are correct! Whether in an
assembled or dissociated
configuration, the exchanger
and motor must always
be in the same position
of the exchanger and
motor are correct! The
motor must not be placed
above or below the
exchanger.
to each other.