Dual Handlebar (Me 339); Grass Catcher Box; Central Cutting Height Adjustment; Notes On Working With The - Viking ME 339 Manual De Instrucciones

● Pull or push upper handlebar (4) out
of/into lower handlebar to the desired
handlebar height.
● Hold upper handlebar (4) with one hand
and close quick-clamping device (5).
● Quick-clamping device (5) must be
sufficiently tightened so that it closes
completely and handlebar is firmly
locked in lower handlebar. If necessary,
release quick-clamping device again
and turn knurled nut (6).

8.2 Dual handlebar (ME 339)

Danger of pinching!
The upper handlebar can be fold
down when the rotary handles are
released. For this reason, always
hold the upper handlebar (2) with
one hand at its highest point when
you unscrew the rotary handles.
Folding down handlebar:
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Loosen rotary handles (1) until they can
be moved easily backwards and
forwards in machined grooves, then
fold down upper handlebar (2)
forwards.
Working position (to push machine):
● Fold up upper handlebar (2) rearwards
and hold with one hand.
● Tighten rotary handles (1). Ensure
correct position of cable guide (3).
0478 121 9917 E - EN

8.3 Grass catcher box

Attaching:
● Open discharge flap (1) and hold
it open.
● Attach grass catcher box (2) to
mountings (4) on rear of machine by
means of locating lugs (3).
● Close discharge flap (1).
Detaching:
● Open discharge flap (1) and hold it
open.
● Lift grass catcher box (2) and remove
8
rearwards.
● Close discharge flap (1).
8.4 Central cutting height
adjustment
Five different cutting heights
between 30 mm and 70 mm can be set.
Level 1 = lowest cutting height
Level 5 = highest cutting height
Lawn mowers for Great Britain:
Six different cutting heights between
20 mm and 70 mm can be set.
Level S = lowest cutting height
Level 5 = highest cutting height
In order to prevent damage, the
lowest cutting height must only be
used on even lawns (without
bumps).
Setting cutting height:
● Push height adjustment lever (1) away
from lawn mower slightly until lever is
released from locating lugs (2).
● Increasing cutting height:
Raise lawn mower using height
adjustment lever (1) (push lever
9
forwards).
Decreasing cutting height:
Lower lawn mower using height
adjustment lever (1) (push lever
rearwards).
● Push height adjustment lever (1)
towards lawn mower slightly until
locating lugs (2) engage in lever. The
selected cutting height can be read off
at the front locating lug (3).

9. Notes on working with the

machine
9.1 General
Risk of injury!
Untangle any knots in the cable
10
immediately.
Guide the electric cable behind you
when mowing. Electric cables can
be inadvertently cut when mowing
and present a tripping hazard. They
therefore involve a high accident
risk. For this reason, mow so that
the electric cable is always visible
in the area of grass that has already
been cut.
To ensure a perfect, thick lawn, mow
regularly and keep the grass short.
Do not cut the lawn too short in hot, dry
conditions as it will dry out or burn in the
sun and become unsightly.
The cutting pattern will be better with a
sharp blade than with a blunt one; the
blade should therefore be sharpened
regularly (VIKING specialist dealer).
35