Working With Your Machine - Viking ME 339 Manual De Instrucciones

VIKING specialist has a supply of
replacement stickers and all the other
spare parts.
The machine must only be used in good
operating condition. Before each use,
check whether:
– The machine is properly assembled.
– The cutting tool and the entire cutting
unit (mowing blade, fastening
attachments, mowing deck housing)
are in good condition. In particular
check for secure fastening, damage
(notches or cracks) and wear.
– The safety devices (e.g. discharge flap,
housing, handlebar, motorstop lever)
are in good condition and working
properly.
– The grass catcher box is undamaged
and correctly installed; a damaged
grass catcher box must not be used.
– The run-down brake of the electric
motor is functioning.
Carry out any necessary work or consult a
specialist dealer. VIKING recommends
VIKING specialist dealers.
Observe the instructions in section
"Dangers caused by electrical current"
( 4.8).
Never switch the motor on without a
correctly installed blade. Risk of motor
overheating.

4.5 Working with your machine

Never work when animals or
persons, particularly children,
are in the danger area.
Do not work at ambient temperatures
below +5°C (41°F).
0478 121 9918 B - EN
Only work during the day or with good
artificial light.
Do not operate the machine in the rain or
during thunder storms, particularly when
there is a risk of lightning strike.
Caution – risk of injury!
Never put hands or feet on or
underneath rotating parts.
Never touch the rotating blade.
Always keep away from the discharge
opening.
Always observe the safety distance
provided by the handlebar. The handlebar
must always be installed correctly and
must not be modified. Never operate the
machine with the handlebar folded down.
The switch and safety devices installed in
the machine must not be removed or
bypassed. In particular, never secure the
motorstop lever to the handlebar (e.g. by
tying it).
Never attach any objects to the handlebar
(e.g. work clothing). Extension cables
must never be wrapped around the
handlebar.
The risk of accidents is higher if the ground
is damp due to increased danger of
slipping.
Particular caution should be exercised
during working in order to prevent slipping.
If possible, avoid using the machine when
the ground is damp.
Do not leave the machine in the rain.
Switching on the machine:
Exercise care when switching on the
machine and observe the instructions in
the section "Initial operation of the
machine". ( 11.)
Keep your feet a safe distance from the
cutting tool.
Place the machine on an even surface
before switching it on.
The machine must not be tilted before it is
switched on or during switching-on.
Do not switch on the motor if the discharge
chute is not covered by the discharge flap
or the grass catcher box.
Avoid switching the machine on repeatedly
within a short period of time; in particular
avoid "playing" with the ON button. Risk of
motor overheating.
Working on slopes:
Always work across and back on slopes,
never up and down.
If the user loses control when mowing up
and down, there is a risk of being run over
by the machine.
Be particularly careful when changing
direction on a slope.
Always ensure good stability on slopes
and avoid mowing on excessively steep
slopes.
For safety reasons, the machine must not
be used on slopes with an inclination of
more than 25° (46.6%). Risk of injury!
A slope inclination of 25° corresponds to a
vertical height increase of 46.6 cm for a
100 cm horizontal distance.
33