Lorentz PS150 Boost Manual De Instalación Y Operación página 27

Terminal Description: PS150-UL to PS200-UL / PS600 to PS4000
Figure 6: Terminal PS150-UL to PS200-UL / PS600 to PS4000
GND + ̶
Socket Terminal
Ground GND
POWER IN
Well probe
Float switch
Jumper:
Battery Mode
Flow meter
Pressure sensor
Output to
motor
GND
1 2 3 4 5 6 7
Connection
connected to protective ground wire (PE)
+ connect to positive terminal of PV module
– connect to negative terminal of PV module
1 connection to NC
2 connection to COM
3 connect N.O.
4 connect ground
5 connect N.C.
6 connect cable jumper for battery mode
7 connect cable jumper for battery mode
8 connect to signal
9 connect to COM
10 connect positive (+)
11 connect negative (–)
L1 connect to the L1 phase of the motor
L2 connect to the L2 phase of the motor
L3 connect to the L3 phase of the motor
connect to protective motor ground wire (PE)
Controller Installation
8 9 L1 L2
10 11
L3 GND
Table 5: Terminal explanation
Operative only
in controllers
equipped with
DataModule
25