Current Clamp (Optional) - Abicor Binzel FEC Manual De Instrucciones

FEC

6.3 Current clamp (optional)

If required by the welding conditions, a current clamp may be used instead of a ground cable.The clamp is connected to the
FEC by the 4-pole plug and the ground cable or cable assembly is laid in it. Once the welding process begins, the FEC
receives a signal and starts the fume extraction process.
1 A / Auto button
Fig. 6 Current clamp
1 Connect the plug with the socket for current clamp (4).
2 Lay the ground cable or cable assembly in the current clamp.
1 Current clamp
Fig. 7 Cable assembly laid in current clamp
NOTICE
• You must ensure that the red dot on the current clamp always faces the direction of the current flow.
3 Press the A / Auto button (1) on the control panel..
The fume extraction system starts automatically when the welding process starts.
BAL.0533.0 • 2018-10-04
4
2 Motor protective switch 3
1
2 Red dot
1
2
3
Power cable connector 4 Socket for current clamp
2
3
3 Cable assembly
6 Commissioning
EN - 15