Software - Migatronic FLEX2 3000 Compact Manual De Instrucciones

In case of exchange of the control unit, software must
be reloaded, using an SD card.
Latest software can be downloaded under Product
software at www.migatronic.com/login. Save the
software on an SD card containing the folders and one
or more of the files shown below.
To order SD card, use item no. 12646000.
Software reading
2
 Insert the FLEX
3000 Compact SD-card in the
slide in the right side of the machine.
 Turn on the machine.
 The display flashes shortly with six lines.
 Wait until the set current is displayed.
 Turn off the machine and remove the SD card
 The machine is now ready for use.

SOFTWARE


All machine user settings are deleted when
the file 10645900.bin has been inserted.
Therefore, always remove the SD-card from the
machine after the software update. Thereby,
continuous software update is avoid each time
the machine is turned on.
If the SD-card contains software for other units e.g.:
10020115.cry
10020113.cry
These units will be updated if they are connected to
the CAN network.
Please note that this update will be longer in time, so
please do not turn off the machine until the standard
control panel will be displayed at
2
FLEX 3000 Compact.
Licence SW
If additional licences for programs or special functions
have been bought, then the MigaLic.dat files should
be read by the machine in the same way as SW-
packages. Please remember to save a backup file.
The MigaLic.txt file contains information about
machine licence number and containing licences at
the SD-card.
23
RWF
RCI