Selecting Dual Band Mode/ Single Band Mode; Selecting A Frequency Band - Kenwood TM-D710GA Manual De Instrucciones

SELECTING DUAL BAND MODE/ SINGLE BAND MODE

You can switch the transceiver between dual band operation and single band
operation by pressing [BAND SEL] (1s) of your selected band.
Dual band mode:
Single band mode (band A only):
Note: You can also turn the center partition bar display off {Menu No. 928}.

SELECTING A FREQUENCY BAND

You can change the default frequency band for bands A and B.
1 Select band A or B by pressing the [BAND SEL] control or [PF2].
2 Press [F], [BAND SEL] of your selected band.
• Each time you press [F], [BAND SEL], you cycle to the next frequency band.
• The default setting of the [PF1] key also allows you to cycle to the next frequency
band (TM-D710GE).
• When masking a band, you are restricted to using only the selectable band.
• When receiving 2 signals on the same band, the image interference, sensitivity, etc.,
Performance will decrease.
• Band A: 118 >> 144 (default) >> 220 >> 300 >> 430/440 (MHz).
• Band B: 144 >> 220 >> 300 >> 430/440 (default) >> 1200 (MHz).
Note: TM-D710GE models use the 430 MHz band and TM-D710GA models use the 440 MHz
band.
20