Location Requirements - Sears Kenmore 106.5176 Serie Manual De Uso Y Cuidado

2. Open the freezer door. On the refrigerator door, place the handle on
the shoulder screws with the setscrews facing the freezer.
A
A. Shoulder screws
B. Setscrews inside the handle
3. Firmly push the handle toward the door until the handle base is flush
against the door.
4. While holding the handle, insert the short end of the hex key into the
upper hole and slightly rotate the hex key until it is engaged in the
setscrew.
5. Using a clockwise motion, tighten the setscrew until it begins to contact
the shoulder screw.
6. Repeat steps 4 and 5 to begin fastening the lower setscrew.
7. Once both setscrews have been partially tightened as outlined in the
previous steps, fully tighten both the upper and lower setscrews.
IMPORTANT: When the screws feel tight, tighten them an additional
quarter-turn. The handle is not properly installed without this extra
tightening.
8. Open the refrigerator door and close the freezer door. Repeat steps 2
through 7 to install the other handle onto the freezer door with the
setscrews facing the refrigerator.
9. Save the hex key and all instructions.
To Remove the Handles:
1. While holding the handle, insert the short end of the hex key into the
lower setscrew hole and slightly rotate the hex key until it is engaged
in the setscrew.
2. Using a counterclockwise motion, loosen the setscrew a quarter­turn at
a time.
3. Repeat steps 1 and 2 for the upper setscrew. Gently pull the handle
away from the door.
4. If necessary, use a Phillips screwdriver to remove the shoulder screws
from the door.
B
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
IMPORTANT: This refrigerator is designed for indoor household use only.
To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.27 cm) of
space on each side and at the top. Allow for 1" (2.54 cm) of space behind
the refrigerator. If your refrigerator has an ice maker, allow extra space at
the back for the water line connections. When installing your refrigerator
next to a fixed wall, leave a 2" (5.08 cm) minimum space on each side
(depending on your model) to allow the doors to swing open.
NOTES:
This refrigerator is intended for use in a location where the
temperature ranges from a minimum of 55°F (13°C) to a maximum of
110°F (43°C). The preferred room temperature range for optimum
performance, which reduces electricity usage and provides superior
cooling, is between 60°F (15°C) and 90°F (32°C). It is recommended
that you do not install the refrigerator near a heat source, such as an
oven or radiator.
Normal minimum cabinet cut-out width required for product
installation is 36" (91.44 cm). However, if the product is placed against
an extended wall and the ability to remove the crisper pans is desired,
an additional 18" (45.72 cm) of cabinet width is required, so a total
cabinet opening width of 54" (137.16 cm) is recommended.

Location Requirements

WARNING
Explosion Hazard
1 / " (1.27 cm)
2
2" (5.08 cm)
9