Replacing The Rotor Blades - Carrera RC Sky Hunter Instrucciones De Montaje

Range of functions of the remote control Funktionsübersicht des Controllers
4
5
6
2
10
11
11
12
Description of helicopter
1
1
1. Coaxial rotor system
2. Tail rotor
3. LiPo battery holder
4. Landing skids

Replacing the rotor blades

1
1
3
2
7
8
9
1. Antenna
2. Power switch (ON / OFF)
3. Control LED
4. Gas · tail (spinning in circles)
5. Trimmer for gas
6. Trimmer for tail
7. Forward/backward
right/left pitch
8. Trimmer for forward/backward
9. Trimmer for right/left pitch
10. Battery compartment
11. Slot for keeping
Joystick extensions
12. Joystick extensions
to screw on lever 4. & 7.
2
3
4
Should the rotor blades be damaged,
you should replace them immediately.
Make sure they are installed the correct
way round.
Controlling the helicopter
In case you don´t know the control functions of your Carrera RC helicopter yet,
please take some minutes before the first flight in or to make yourself familiar
with them. The descriptions left or right refer to the view out of the cockpit
(pilote´s view).
1
2
+
‒
3
r
l
4
l r
5
‒
6
+
‒
12
With the throttle being at minimum posi-
tion and the trim of throttle in medium or
lower position, the rotor blades are not
going to revolve. Push the throttle up to
+
increase the rotational speed of the
main rotor blades. Increase the rota-
‒
tional speed of the main rotor blades
and the model will start to ascend.
If you push down the throttle and thus
reduce the rotational speed of the main
rotor blades the helicopter will descend.
When the model has lifted off the
ground you can get it into stationary
hovering without abrupt ascending or
descending by carefully moving the
throttle upwards and downwards.
Move the left lever (tail) to the left and
the helicopter´s nose turns (yaws)
round the main rotor´s axis in a circle to
the left. Move the left lever (tail) to the
right and the helicopter´s nose turns
(yaws) round the main rotor´s axis in a
circle to the right.
Use the trimmer for tail until you have
reached a stable neutral position of the
helicopter when hovering, without
moving the left lever (tail).
The forward-/backward lever controls
the helicopter´s pitch forward and back-
ward. When shifting the lever forward
the nose of the helicopter will move
downwards and the helicopter will fly
+
forward. When shifting the forward-/
backward lever backward the helicopter
will move backwards and the helicopter
will fly backward. Use the timmer for
forward-/backward in order to achieve a
stable neutral position and to avoid that
the helicopter flies forward or backward
when hovering without moving the for-
ward-/backward lever.