Computer Mode; Selecting Computer Mode; Selecting Computer System; Automatic Multiscanning System - Eiki LC-XNB2W Manual De Instrucciones

COMPUTER MODE

Select COMPUTER mode by pressing the MODE button on the Top
Control or the COMPUTER button on the Remote Control Unit.
Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select Computer
press the SELECT button.
CURRENT MODE DISPLAY
When selecting the Computer Mode, the Current Mode display
appears. It shows the information of the computer of the mode
selected.

AUTOMATIC MULTISCANNING SYSTEM

This projector automatically tunes to most different types of computer
based on VGA, SVGA, XGA or SXGA (refer to "COMPATIBLE
COMPUTER SPECIFICATION" on page 23). When selecting
Computer, this projector automatically tunes to the incoming signal
and projectors the proper image without any special setting. (Setting
of the Computer System may be required when connecting some
computers.)
Note : The projector may provides the messages below.
Go to PC adj.
No signal
SELECT COMPUTER MODE MANUALLY
GB
To set the Computer system manually, select the mode on the ON-
SCREEN MENU.
1 Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
SYSTEM and press the SELECT button. Another dialog box
COMPUTER SYSTEM Menu will appear.
2 Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the system that you want to set,
and then press SELECT button.
22

SELECTING COMPUTER MODE

DIRECT OPERATION
MENU OPERATION

SELECTING COMPUTER SYSTEM

The projector cannot discriminate or detect the
input signal from the computer. Adjust and set the
computer system manually. (Refer to page 24.)
There is no signal input from the computer. Make
sure the connection of the computer and the
projector is set correctly.
(Refer to TROUBLESHOOTING on page 35.)
MODE button
COMPUTER
VIDEO
and
Providing the information of the computer detected
by the projector.
SYSTEM BOX
It displays the SYSTEM
being selected.
The system being selected.
The systems on this
dialog box can be
selected.
It closes the
SYSTEM Menu.