Assembling The Heater - Cointra CPA 6 Instrucciones De Uso, Instalación Y Mantenimiento

dispersed in the domestic environment. Otherwise
there may be risk of suffocation and intoxication or
explosions and fire.. Therefore the place of instal-
lation must be free of dust, flammable materials or
objects or corrosive gases.
Position the water heater as close as possible to the hot
water taps, near the sink, but NEVER above a cooktop.
It must also be situated as close as possible to the flue
or the start of the flue gas exhaust pipe.
If the unit is installed inside a cabinet or joi-
ned laterally to other elements, space must be
allowed for removing the casing and perfor-
ming normal maintenance activities.
A
fig. 5 - Minimum distances
On each side
A
B -
In front
C
38
EN
A
B
>2cm
>50cm
>2cm
cod. 3541S050 - Rev. 01 - 07/2019

2.3 Assembling the heater

Before assembling the heater,
make sure the water and gas
connections are properly secu-
red, identified, and positioned.
See the dimensions and con-
nections in section 4.2.
• Fix the plugs and hooks on the wall, in a central po-
sition vertical to the appliance, as shown in the figure
below.
• Mark the position of the bottom screws
• Hang the water heater on the plugs+hooks and tighten
the screws for fixing the unit to the wall.
• Connect the hot and cold water flexible tubes, remem-
bering to check their tightness. To avoid circulation pro-
blems, do not remove the cold water inlet filter.
85
84
fig. 6 - Dima di montaggio CPA 11
CPA
170
85
84
168