Stanley ProSet XT3 Manual De Instrucciones página 5

E N G L I S H
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if
not avoided, may result in property damage.
Improper operation or maintenance of this product could result in serious injury and property damage.
Read and understand all warnings and operating instructions before using this equipment. When using
power tools, basic safety precautions must always be followed to reduce the risk of personal injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
WARNING:
• DO NOT use outside the design intent of Placing STANLEY Engineered Fastening Blind Rivets.
• Use only parts, fasteners, and accessories recommended by the manufacturer.
• DO NOT modify the tool in any way. Any modifi cation to the tool is undertaken by the customer and will
be the customer's entire responsibility and void any applicable warranties.
• Prior to use, check for misalignment or binding of moving parts, breakage of parts, and any other
condition that aff ects the tool's operation. If damaged, have the tool serviced before using. Remove any
adjusting key or wrench before use.
• The tool must be maintained in a safe working condition at all times and examined at regular intervals
for damage and function by trained personnel. Any dismantling procedure will be undertaken only by
trained personnel. Do not dismantle this tool without prior reference to the maintenance instructions.
• The operating supply air must not exceed 7 bar (100 PSI).
• Operators and others in work area must wear approved safety glasses with side shields. Always wear
safety glasses and ear protection during operation.
• Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from
moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
• DO NOT operate a tool that is directed towards any person(s).
• DO NOT operate tool with the nose casing removed.
• Adopt a fi rm footing or a stable position before operating the tool.
• Prior to use, inspect airlines for damage, all connections must be secure. Do not drop heavy objects on
Hoses. A sharp impact may cause internal damage and lead to premature hose failure.
• DO NOT lift the placing tool by the hose. Always use the placing tool handle.
• Vent holes must not become blocked or covered.
• Disconnect the air hose from the tool before performing any maintenance, attempting to adjust, fi t or
remove a nose assembly.
• Keep tool handles dry, clean, and free from oil and grease.
• When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent activation.
• Never leave operating tool unattended. Disconnect air hose when tool is not in use.
• Adequate clearance is required for the tool operator's hands before proceeding.
• DO NOT abuse the tool by dropping or using it as a hammer.
• Keep dirt and foreign matter out of the hydraulic system of the tool as this will cause the tool to
malfunction.
• Care should be taken to ensure that spent mandrels do not create a hazard.
• The mandrel collector must be emptied when approximately half full.
• DO NOT use the tool without mandrel collector installed.
• DO NOT let air exhaust opening on the mandrel collector face in the direction of the operator or other
persons.
• Contact with hydraulic fl uid should be avoided. To minimise the possibility of rashes, care should be taken
to wash thoroughly if contact occurs.
• Material Safety Data Sheets for all hydraulic oils and lubricants is available on request from your tool
supplier.
STANLEY Engineered Fastening policy is one of continuous product development and improvement
and we reserve the right to change the specifi cation of any product without prior notice.
6