Delta RT-40 Manual De Instrucciones página 10

Attach the extension wing to the saw with three M10 x 35mm hex-head bolts (A) Fig. 5.
Note: Loosely tighten the bolts for further adjustment.
Place a straight-edge (A) Fig. 6 on the saw (B) and the extension table (C) over the first bolt to check the level. When
the two are level, tighten the bolt. Do the same with the far bolt. Tighten all hardware securely.
Install the other extension wing in the same manner.
HOW TO ATTACH THE RIP FENCE SUPPORT BRACkET
A
B
Fig. 7
Attach the rip fence support bracket (A) Fig. 7 to the saw (B) with two M8 x 35mm hex-head bolts (C) Fig. 7.
Note: Loosely tighten the bolts for further adjustment.
Place a straight-edge on the saw (B) and the fence support bracket (A) to check the level. When the two are level,
tighten the bolts. Tighten all hardware securely.
HOW TO ATTACH A SAW BLAdE
NOTE: No blade is supplied with this saw.
1, Remove the table insert and raise the saw arbor to its
full height by turning the elevation handwheel.
NOTE: Turn the arbor bolt clockwise to loosen.
2. Use the provided blade wrench to remove the arbor
bolt (A), the retainer (B), the spacer (C), and the blade
flange (D).
NOTE: Leave the inside blade flange (E) on the arbor.
NOTE: Press the lock button (A) Fig. 11 to prevent the
arbor from rotating.
A
Fig. 5
C
Fig. 6
B
A A
B
A
10
B
C
A
Fig. 8
d
C Fig. 9
E