Bevel Crosscutting; Compound Mitering - Delta RT-40 Manual De Instrucciones

Sierra de eje con inclinación hacia la izquierda de 355 y 406 mm (14”/16”)

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Never use the fence as a cut-off gauge when cross-cutting.

When cross-cutting a number of pieces to the same length,

clamp a block of wood (B) to the fence and use it as a cut-

off gauge (Fig. 55). The block (B) must be at least 3/4" thick

to prevent the cut-off piece from binding between the blade

and the fence during removal from the saw table. Always

position this block of wood in front of the saw blade. Once

the cut-off length is determined, lock the fence and use the

miter gauge to feed the work into the cut.

When using the block (B) Fig. 55 as a cut-

off gauge, position the rear end of the block so that the

workpiece is clear of the block before it enters the blade.

MITERINg

Mitering (Fig. 56) is the same as crosscutting except the miter gauge (C) is locked at an angle other than 0°. Hold the workpiece

firmly against the miter gauge and feed the work slowly into the blade to prevent the workpiece from moving.

Use caution when starting the cut to prevent

binding of the guard against the workpiece. Miter angles

greater than 45° may force the guard into the saw blade

and damage the guard. Before starting the motor, test

the operation by feeding the workpiece into the guard. If

the guard contacts the blade, place the workpiece under

the guard, not touching the blade, before starting the

motor. Certain workpiece shapes, such as mouldings,

may not lift the guard properly. Feed the work slowly to

start the cut.