Permanently De-Registering The Water Lter; Troubleshooting - melitta PASSIONE Manual De Instrucciones

Troubleshooting

Permanently de-registering the water lter

If you have removed an inserted water lter and want to continue operating
the appliance without a water lter, de-register the water lter from the
appliance:
1. Remove the water tank.
2. Remove the water lter (see Fig. 18).
3. Fill the water tank.
4. Press the "Service" button and also the "Large cup" direct key for longer
than 2 seconds.
» The water lter is de-registered.
» The water hardness is reset to the water hardness that the appliance
had stored prior to inserting a water lter.
5. Adjust the water hardness if necessary (see section 6.4 Setting the water
hardness on page 78).
8 Troubleshooting
If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline (local rate).
The service number can be found behind the side cover (10) or in the Ser-
vice area of our website.
Problem
Co ee only emerges
from the outlet in drips.
Co ee does not ow.
When foaming milk,
there is not enough
milk foam.
94
Cause
Grinding neness is
too ne.
Appliance is soiled.
Appliance is covered
inside with limescale.
Water tank is not lled
or is not correctly
inserted.
Brewing unit is
clogged.
Selector switch is not in
the correct position.
Cappuccinatore is
soiled.
Action
Set a coarser grinding neness
ƒ
(see section 6.7 on page 80).
Clean the brewing unit (see
ƒ
section 7.2 on page 82).
Run the cleaning programme
ƒ
(see section 7.4 on page 85).
Run the descaling program
ƒ
(see section 7.5 on page 88).
Fill the water tank and ensure
ƒ
it is positioned correctly (see
section 4.4 on page 67).
Clean the brewing unit (see
ƒ
section 7.2 on page 82).
Turn the selector switch to
ƒ
the correct position (see sec-
tion 5.6 on page 74).
Clean the Cappuccinatore (see
ƒ
section 7.3 on page 84).