Connecting The Device - Dometic Waeco CombiPower 2012 Instrucciones De Montaje

_CombiPower_IA_DE-IT.book Seite 81 Freitag, 21. Oktober 2011 8:10 20
CombiPower
7

Connecting the device

7.1 Fastening the device
When selecting the installation location, observe the following instructions:
 The device can be mounted horizontally or vertically.
 The device must be installed in a place that is protected from moisture.
 Do not install the device near flammable materials.
 Do not install the device in a dusty environment.
 The place of installation must be well ventilated. A ventilation system must
be present for installations in small, enclosed spaces. The clearance
around the device must be at least 25 cm.
 The air inlet on the underside and the air outlet on the back of the device
must remain clear.
 At ambient temperatures above 40 °C (for example in engine or heating
rooms, or direct sunlight), the device reduces the power to prevent itself
from overheating.
 The device must be installed on a level and sufficiently sturdy surface.
 Do not install the device in the same area as the batteries.
 Do not install the device above batteries, because they can emit corrosive
sulphur fumes that will damage the device.
NOTICE!
A
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
Fasten the device as follows:
➤ Fasten the device with one screw through each hole in the holders.
EN
Connecting the device
81