Setting The Dip Switches - Dometic Waeco CombiPower 2012 Instrucciones De Montaje

_CombiPower_IA_DE-IT.book Seite 86 Freitag, 21. Oktober 2011 8:10 20
Connecting the device
7.3

Setting the DIP switches

You can adapt the device to the existing electrical system using the DIP
switches SWA and SWB. The remote control settings take priority over the
settings of the DIP switches (default settings).
➤ Remove the cover (fig. 1 7, page 3).
NOTICE! Beware of damage
A
The settings marked in the following table with the symbol a may
only be carried out by experts.
➤ Set the DIP switches as required.
The setting options for the DIP switches are shown on the following
pages.
➤ Restart the devices to store the values.
For this purpose switch off the main switch and switch it on again.
➤ Put the cover (fig. 1 7, page 3) back on.
86
CombiPower
EN