Cleaning And Maintenance; Troubleshooting - Mobicool W45 Instrucciones De Uso

_W48.book Seite 10 Donnerstag, 23. Oktober 2008 4:42 16

Cleaning and maintenance

6 Cleaning and maintenance
Caution!
e
Always disconnect the device from the mains before you clean and
service it.
Caution!
a
Do not clean the cooler under running water or in dish water.
Caution!
a
Do not use abrasive cleaning agents or hard objects during clean-
ing as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
7

Troubleshooting

Fault
Your cooler does not func-
tion (plug is inserted).
Your cooler does not cool
(plug is inserted).
When operating from the
12 V socket (cigarette
lighter):
The ignition is on and the
cooler is not working.
Pull the plug out of the
socket and make the fol-
lowing checks.
10
Possible cause Suggested remedy
There is no voltage The ignition must be switched on in most
present in the 12 V vehicles for voltage to flow at the ciga-
socket (cigarette rette lighter.
lighter) in your vehicle.
No voltage present in Try using another plug socket.
the AC voltage socket.
The inner fan or the This can only be repaired by an author-
cooling element is ised customer services unit.
defective.
The fitting of the If the plug of your cooler becomes very
12 V plug is dirty. This warm in the 12 V socket fitting, either the
results in a poor electri- fitting must be cleaned or the plug has
cal contact. not been assembled correctly.
The fuse of the 12 V Replace the fuse (5 A) in the 12 V plug
plug has blown. (fig. 3 1, page 4).
The vehicle fuse has Replace the vehicle's 12 V socket fuse
blown. (usually 15 A). Please refer to the oper-
ating manual of your vehicle.
W48 DC/AC