Product Description; Installation And Maintenance; Technical Data - Gardigo 70095 Manual De Instrucciones

Instructions for Use
Article-No. 70095
Dear Client,
Congratulations for choosing one of our quality products. Ple-
ase follow these instructions carefully and keep them with
you.
Solar Animal Repellent through vibrations –
no chemicals, no ground pollution!

1. Product description

This animal repeller device is one of the new generation of re-
pellers! It generates vibrations in approx. 25 sec intervals for
repelling ant, snakes and rodents and an additional frequen-
cy within the range of 12.000- 32.000 Hz ± 500 Hz. Outdoor
test showed that these specially generated vibrations have
an optimum effective area of approx. 200 m², depending on
condition of soil. Because the tone frequencies and vibrations
are intolerable for many soil animals, they migrate to other
areas within just a few days. Other useful animals are not
harmed. The Solar Animal Repeller can be used in the garden,
in the field or in other outdoor areas with unwanted rodents.
The finely tuned electronic components and the efficient solar
modules guarantee constant function even with poor light.
This appliance not only repels rodents, ants, mice, spiders and
snakes!

2. Installation and maintenance

Insert the device into the ground, so that up to ¾ of the alu-
minium stake is beneath the surface. To start up, select the
operating mode on the underside of the housing. The animal
repellent device is now ready for operation.
Check the function of the device regularly. In case it does not
work normally any more, a replacement of the rechargeable
battery might be necessary (see point 3).
Operating modes:
1. [On] Tone frequency
2. [OFF] Tone frequency
3. Replacement of the rechargeable
battery
1. Remove the transparent housing cover..
2. Carefully take off the solar panel from the rechargeable
battery which is underneath. When doing so, make sure
that the cable connection between the solar panel and the
circuit board which is underneath the rechargeable battery,
is left intact and is not damaged..
3. Remove the old rechargeable battery from its fitting.
4. Insert a new rechargeable battery size Mignon (AA) and
type Ni-MH with 1.2 V and 850 mA. When doing so, mind
the correct polarity as shown on the bottom inside the
battery fitting.
5. Carefully place the solar panel back on the rechargeable
battery..
6. Reattach the transparent casing cover to the casing body.

4. Technical data

· Power supply:
2 rechargeable battery, size Mignon (AA), type Ni-MH, 1.2
V, 850 mA (included); can be replaced if necessary
· Casing: weather-proof, Stable aluminium stake
· Effective area:
approx. 700 m², depending on condition of soil
· Frequency range:
approx. 12.000- 32.000 Hz ± 500 Hz, self-controlling
· Electricity supply: Polycrystalline solar cells
· Interval:
approx. 3 sec on, approx. 25 sec off (break interval)
· Voltage reserve:
up to 7 days without exposure to light
· Readiness for operation:
immediate operating and charging function, even at low
incidence of light
5. Installation suggestion
Place the repeller in such a position that animals will have the
possibility to flee from your land.
After about 5 – 6 weeks the device/s should be moved appro-
ximately 4-5 metres in the direction of the escape route